PDF Download available at bottom of page

 INTRODUCTION 

This Procedure shows how to Disable the “Display Message” being displayed on the Monitor. 

Equipment required: PoE Network Switch or 12v DC PSU (to power the PVM10CAMN), small torx wrench that comes with the PVM10CAMN to remove rear cover, 1 x CAT5e patch lead and PVM10CAMN IR remote

  1. Power up Monitor
  2. Take PVM10CAMN IR remote and press menu button (fig1)
  3. Select “PVM Function” using the up/down buttons (fig2)
  4. Select “Display Message” using the up/down button
    1. Once highlighted press “OK” button to “OFF” (fig3) 
  5. Once complete use Up/Down buttons to highlight “Exit” press “OK” to exit out of Menu’s (fig4)


This completes the procedure.